Last Thursday was a disaster where I worked hard and quickly accomplished nothing
![Crying or Very Sad :cry:](./images/smilies/icon_cry.gif)
One irritating job that has needed doing on the 580BT was that there is a crack in the undercarriage tub, these are quite common and a previous owner has splattered weld on the tub like its going out of fashion, the tub had cracked along this weld, additionally they have welded on a towing eye which I could not face grinding off.
I dug the crack out with my angle grinder and would have had a bash at welding it myself but Andrew kindly MIG welded this for me after which I ground it down a bit , then cleaned it off and primed it, then top coated it, job done, so at least today I got one useful job done, result.
![Thumb up :thumbup:](./images/smilies/icon_b_thumbup.gif)
I'm not too sure if you will see the crack on the photos or not?
Jeremy
![Image](http://www.classicmachinery.net/forum/images/userpix/112_275267B7QRDW01691698938.jpg)
![Image](http://www.classicmachinery.net/forum/images/userpix/112_1AFQF7W3AD801691698938.jpg)
![Image](http://www.classicmachinery.net/forum/images/userpix/112_2XFUVEE5H7SWO1691698938.jpg)
![Image](http://www.classicmachinery.net/forum/images/userpix/112_34ARD2UUSDKW41691698938.jpg)
![Image](http://www.classicmachinery.net/forum/images/userpix/112_V4UZ4081N6OZ1691698938.jpg)
![Image](http://www.classicmachinery.net/forum/images/userpix/112_LT3Q1PKQRJT61691698938.jpg)