Hymac 141b hydraulic problem
-
Topic author - Posts: 3
- Joined: Wed Dec 12, 2012 2:43 am
- Real name: Damien Devlin
Hymac 141b hydraulic problem
Hi all , I have a 141b and I have put 2 new brass plates in my pumps as they got wore when I lent my neighbour my machine and he run her whilst she was low on oil . I'm having problems setting up the control valves on the pumps . Can anyone point me in the right direction . Regards Damien
-
- Moderator
- Posts: 8677
- Joined: Sun Aug 05, 2007 8:36 pm
- Real name: Jeremy Rowland
- Has thanked: 1873 times
- Been thanked: 1692 times
Re: Hymac 141b hydraulic problem
Hi Damien, welcome to the site, perhaps you could enlighten us a little more about the problems you are experiencing with your machine? Were your hydraulic pumps tested for the correct output after they had been repaired?
Jeremy
Jeremy
-
Topic author - Posts: 3
- Joined: Wed Dec 12, 2012 2:43 am
- Real name: Damien Devlin
Re: Hymac 141b hydraulic problem
Hi all , the pumps are working perfectly and putting up over 3500 psi but when I track forward she stalls the engine . I put 2 clocks , one on each pump and set them at 40 psi under no load but now she will do nothing . I'm not exactly sure which screw under each pump on the control does what . Any ideas would be greatly appreciated
Who is online
Users browsing this forum: No registered users and 54 guests