Hydro clamp issues
-
Topic author - Posts: 384
- Joined: Mon Jun 28, 2010 8:15 pm
- Real name: grant
- Location: arbroath
- Has thanked: 10 times
- Been thanked: 9 times
- Flag:
Hydro clamp issues
Hi my project 21 3cx has developed a problem the hydro clamps release if you stop operating the backactor within a few minutes just wondered what the cause could be
-
- Posts: 279
- Joined: Sun Nov 06, 2011 2:09 am
- Real name: phil wheelton
- Has thanked: 1 time
- Been thanked: 29 times
- Flag:
Re: Hydro clamp issues
there is a non return in the system to keep them under pressure, sounds like it's not holding pressure
-
Topic author - Posts: 384
- Joined: Mon Jun 28, 2010 8:15 pm
- Real name: grant
- Location: arbroath
- Has thanked: 10 times
- Been thanked: 9 times
- Flag:
Re: Hydro clamp issues
Hi thanks for reply that's what scot Jcb said aswell it's goin in to get repaired on Monday i'am getting a hired machine on Monday hopefully a 3cx Eco from hewden
-
Topic author - Posts: 384
- Joined: Mon Jun 28, 2010 8:15 pm
- Real name: grant
- Location: arbroath
- Has thanked: 10 times
- Been thanked: 9 times
- Flag:
Re: Hydro clamp issues
Hi ended up getting a 60 plate cat 432e premier with a miller twin lock hydraulic hitch which is the best bit about the machine overall it's not too bad a machine albeit a bit unstable had it on 2 wheels twice today and also was rather smokey I have it again tomorrow then hopefully will get the Jcb back
Who is online
Users browsing this forum: No registered users and 66 guests