My JCB 3C mk2
-
Topic author - Posts: 20
- Joined: Wed Sep 14, 2016 10:21 pm
- Real name: James Holland
- Been thanked: 1 time
- Flag:
Re: My JCB 3C mk2
Thank! I did miss the first one, but I have messaged them asking as no-one bid.
I am collecting a windscreen on Tuesday so will have two sides glazed the poor old gal hasn’t done much since I was last on. Well apart from moving 15 tons of soil lol. I’ve checked the antifreeze for winter
Next job is to fit the new oil pressure gauge pipe. I need to remove the heater tap too and fit a straight out stub instead. Tap is leaking:( I think I’ve found a 1 foot bucket too. I need to do some drainage soon so will come in very handy!!
I am collecting a windscreen on Tuesday so will have two sides glazed the poor old gal hasn’t done much since I was last on. Well apart from moving 15 tons of soil lol. I’ve checked the antifreeze for winter
Next job is to fit the new oil pressure gauge pipe. I need to remove the heater tap too and fit a straight out stub instead. Tap is leaking:( I think I’ve found a 1 foot bucket too. I need to do some drainage soon so will come in very handy!!
-
Topic author - Posts: 20
- Joined: Wed Sep 14, 2016 10:21 pm
- Real name: James Holland
- Been thanked: 1 time
- Flag:
-
Topic author - Posts: 20
- Joined: Wed Sep 14, 2016 10:21 pm
- Real name: James Holland
- Been thanked: 1 time
- Flag:
Re: My JCB 3C mk2
essexpete wrote:Ah so the Essex part not too far then. Looks a bit tarted up but if you are missing one altogether perhaps OK?
No not too far, the door glass should be the only one I need now.
Who is online
Users browsing this forum: No registered users and 61 guests