The Classic Machinery Network

Trying to figure out whats missing from my dumpers wiring ? I think it's either an AllDriver 6000 or 7000, Lister Petter 3 cylinder flat top. I replaced the seat box and I'm not sure what this is beside the ignition ? I reckon its a dynamo regulator, however it wasnt connected and was just a box of rust !! Anyone got any idea what should be there or got a wiring diagram ?

It's not a cut out switch for the drive is it? If you are not in the seat no drive, like excavators. I say that because I have two wires on my seat but no high tech wizardry so just cable tied together and going nowhere

Ian

It's manual clutch drive so no option of cutout switch, the sum total of electrics a starter motor, battery and dynamo !

tfox wrote:It's manual clutch drive so no option of cutout switch, the sum total of electrics a starter motor, battery and dynamo !

There's an alldrive 6000 manual in the download section on here , I looked at it after I posted reply about the cutout switch to find that there is only as you said battery dynamo starter

Unfortunately I reckon it's not a 6000 alldrive as the dumper doesnt seem to correlate with that manual !!