The Classic Machinery Network

Just found it now, very helpful. Thanks very much.

Bit of a shot in the dark here, but I’m wondering if anyone has access to a workshop manual for a Kubota V1505T engine as I need to carry out a head gasket replacement on it.

Many thanks

Sorted

Does anyone know how to fit these locks from the boom end with the pin that actuates the plate?

Cheers

Sound good, thank you

Hi there,

Just wondering about info on the best spec engine oil (and best source) for the above machine, it has the Perkins 4236 in an looking to do the oil change in the next few weeks. Many thanks

This is what mine looks like with the plate:

Ah right that’s interesting then, I did have that off at one point. So I’m guessing when the machine is started with fresh oil again Itl be forced into the torque converter and there’s no need to bleed it anywhere?
Cheers for the reply as well, big help

Where abouts would this rubber grommet be located? I tried to find this the other day with no luck. I did take the bottom rectangle inspection cover off, everything looked fine.

Looking to complete this tomorrow, must be good to go ahead