The Classic Machinery Network

You can see the state of the corrosion, the Allen bolt thread Is clearly visable. The leak off pipe doesn't actually go to the valve block, instead it goes to the motor body. http://www.classicmachinery.net/forum/images/userpix/15153_BRXGEFLEIRST1676892585.jpg http://www.classicmachinery.net/forum/i...

The corrosion is very bad due to when I got the machine under the protection plates it was full of mud etc it had been there for some time. The aluminium in areas must be wafer thin near the internal drillings. I'm thinking if possible it would be better to change first rather than it leak on a job....

I'll try and upload a photo. I think it's a "diverter" valve block

Hi, does anyone have any parts for the Powerfab 1000X similar to the PFL Terrier. I'm looking for the aluminium block which attaches to the drive motors. Thanks

Hi, does anyone know the correct track size for the Powerfab 1000x mini excavator. Thanks

I looked closely at some on eBay and they don't look like they would, I think because of safety and what would be the benefit on a tractor. I've read about how the ones for tractors can by re-pinning a linkage (I think it's the one on the boom section) it can lift higher, for say using a grab etc

Thanks Craig, the photo is very useful, will keep looking

Thanks for that information, I didn't realize that. Would like an original one but maybe to fit my own is a good alternative. Do you have any photos of the one you saw at Cheffins?

I haven't got a picture of one but have seen one on a previous post were someone had seen one at Cheffins auction. I have since found out that the model is the: Liner Rough Rider PA44
I would like to buy one to restore so I can take it to Classic Plant shows.

Does anyone have any information about the Liner digger dumper, the one with the backhoe mounted at the rear which then slews to the dumper skip. Also are there any other manufacturers of the same configuration?